27.12.2020, 19:36
(Dieser Beitrag wurde zuletzt bearbeitet: 27.12.2020, 19:48 von bitbrain2101.)
Hello Evert,
I have uploaded the schematic here, link is active for 1 week. Does your M5a have a remote connector ? There is one shown in the schematic as an option named BU238. If there is a remote connector, you have to put a plug with a wire bridge to it. If there is no remote connector, there are still wires for the remote connector, they have to be soldered together. I mention this, because I had a problem in this area with a M5a. The pinch solenoid in the schematic is M 307 = Rollenmagnet. You can find it in the lower left corner of the schematic. Look for bridge rectifier GR233 in the power supply, check the voltage at C235.
Regards, Tobias
I have uploaded the schematic here, link is active for 1 week. Does your M5a have a remote connector ? There is one shown in the schematic as an option named BU238. If there is a remote connector, you have to put a plug with a wire bridge to it. If there is no remote connector, there are still wires for the remote connector, they have to be soldered together. I mention this, because I had a problem in this area with a M5a. The pinch solenoid in the schematic is M 307 = Rollenmagnet. You can find it in the lower left corner of the schematic. Look for bridge rectifier GR233 in the power supply, check the voltage at C235.
Regards, Tobias
Strom kann erst dann fliessen, wenn Spannung anliegt.