29.01.2019, 17:25
Update
I've got good, and great news.
First the good news, I assembled a small setup to be able to play more of the tapes on my 1/4 inch 4-track recorder. I played the tapes that I previously was afraid had no signals at all, and after some time (8-10 minutes) they too give the expected signals. So far I got 6 tapes, 5 of which hold signals.
The great news i've got, is that I have recorded the reference track briefly by moving the tape up and down. The reference is a 10Khz tone on track 4, as seen on the attached document. Skip to (2:35) on the attached .mp3 file. Its exactly 10Khz on the recording.
314N079 Sample 2 mp3
314N079 documents attached below this post.
Later on when I will make proper scans of all documentation and cases.
It would be useful if we knew the track geometry of the FR-100, FR-600 and Otari MX-5050 8. We should be able to actually see this on the tape by using a magnetic developer solution. They are very expensive to buy and ship, so I have talked with Chuck on how to make it myself. It is quite simple, and he tried it on a floppy disk with good results and no damage to the data. With detailed macro photos we can figure out how well the tracks align.
Stay tuned!
Niels
I've got good, and great news.
First the good news, I assembled a small setup to be able to play more of the tapes on my 1/4 inch 4-track recorder. I played the tapes that I previously was afraid had no signals at all, and after some time (8-10 minutes) they too give the expected signals. So far I got 6 tapes, 5 of which hold signals.
The great news i've got, is that I have recorded the reference track briefly by moving the tape up and down. The reference is a 10Khz tone on track 4, as seen on the attached document. Skip to (2:35) on the attached .mp3 file. Its exactly 10Khz on the recording.
314N079 Sample 2 mp3
314N079 documents attached below this post.
Later on when I will make proper scans of all documentation and cases.
It would be useful if we knew the track geometry of the FR-100, FR-600 and Otari MX-5050 8. We should be able to actually see this on the tape by using a magnetic developer solution. They are very expensive to buy and ship, so I have talked with Chuck on how to make it myself. It is quite simple, and he tried it on a floppy disk with good results and no damage to the data. With detailed macro photos we can figure out how well the tracks align.
Stay tuned!
Niels