10.10.2024, 22:24
(Dieser Beitrag wurde zuletzt bearbeitet: 11.10.2024, 00:33 von Vladislav81.)
Hello Manfred,
Thanks a lot for pointing at SM. I understand almost everything, but I don’t have new old stock brake ribbons.
Yes, fast-forwarding and rewind works good. Can FF a whole roll of Quantegy 478 without much notice, only it slightly slows down at the end of the roll, if using the first FF speed all the way through. Is it correct? The roll is tight after M5.
I took off the tape counter belt, tried running the M5 without it. Getting better, but not too much.
I've noticed that when the tape recorder was shut off for a whole day long, it starts almost very well. Then I FF and rewind the tape, then change it for 50 microns tape, and it starts doing that again.
I have no tools to measure the pinch roller pressure forse.
Regards, Vladislav
Thanks a lot for pointing at SM. I understand almost everything, but I don’t have new old stock brake ribbons.
Yes, fast-forwarding and rewind works good. Can FF a whole roll of Quantegy 478 without much notice, only it slightly slows down at the end of the roll, if using the first FF speed all the way through. Is it correct? The roll is tight after M5.
I took off the tape counter belt, tried running the M5 without it. Getting better, but not too much.
I've noticed that when the tape recorder was shut off for a whole day long, it starts almost very well. Then I FF and rewind the tape, then change it for 50 microns tape, and it starts doing that again.
I have no tools to measure the pinch roller pressure forse.
Regards, Vladislav