Verstehe ich das richtig, dass die alte Aufnahme unbehelligt bleibt und keine neue Aufnahme drübergepackt wird?
Hast du mal die Spannung am Löschkopf gemessen? Zwischen grün und schwarz bzw. weiß und schwarz sollten 30V zu messen sein. Besser noch das Oszilloskop, so du eines hast, anklemmen und schauen, ob die 150kHz da sind oder nicht. Alles natürlich im Aufnahmemodus.
Und am Emitter von Q1 sollten 19V zu messen sein, der liegt noch vor Q2 und Q3. Da beide Kanäle betroffen sind, würde ich zuerst die Punkte abklopfen, die beide Kanäle betreffen, wie eben Q1.
BC639 als Ersatz für die BFR18 ist wohl die beste Möglichkeit, aber die sind halt nur „ähnlich“.
Hast du mal die Spannung am Löschkopf gemessen? Zwischen grün und schwarz bzw. weiß und schwarz sollten 30V zu messen sein. Besser noch das Oszilloskop, so du eines hast, anklemmen und schauen, ob die 150kHz da sind oder nicht. Alles natürlich im Aufnahmemodus.
Und am Emitter von Q1 sollten 19V zu messen sein, der liegt noch vor Q2 und Q3. Da beide Kanäle betroffen sind, würde ich zuerst die Punkte abklopfen, die beide Kanäle betreffen, wie eben Q1.
BC639 als Ersatz für die BFR18 ist wohl die beste Möglichkeit, aber die sind halt nur „ähnlich“.
Viele Grüße aus Kiel,
Hans-Volker
Hans-Volker