30.11.2005, 11:37
Noch mal Thema Röhre im Studio.
Ist das Teil nicht wunderbar (weiß nicht, ob es inzwischen zu kaufen ist)?
![[Bild: C3_101.jpg]](https://tonbandforum.de/bildupload/C3_101.jpg)
Vintec C3 Röhrenmischpult
Why do you use tubes?
The question should read, why was the tube not always used? The tube is almost predestinated to amplify audio signals. The high rate of rise provides for the transmission of highest signal harmonic waves, presupposed the frequency band width is large enough (bandwidth of the Vintec C3 10Hz - 30kHz). Thus providing a clear sound, a high transparency and a unique placement of the instruments. This is also supported by low capacitive couplings of the tube, which cause very small intermodular distortions. The characteristic curve of the non-linear distortion in dependency of the amplitude is substantially flatter and does not show an abrupt operationpoint.
Gruß,
Markus
Ist das Teil nicht wunderbar (weiß nicht, ob es inzwischen zu kaufen ist)?
Vintec C3 Röhrenmischpult
Why do you use tubes?
The question should read, why was the tube not always used? The tube is almost predestinated to amplify audio signals. The high rate of rise provides for the transmission of highest signal harmonic waves, presupposed the frequency band width is large enough (bandwidth of the Vintec C3 10Hz - 30kHz). Thus providing a clear sound, a high transparency and a unique placement of the instruments. This is also supported by low capacitive couplings of the tube, which cause very small intermodular distortions. The characteristic curve of the non-linear distortion in dependency of the amplitude is substantially flatter and does not show an abrupt operationpoint.
Gruß,
Markus